N_031.mp4 Official

: Fully retract the boom. Turn the potentiometer counter-clockwise until it stops to reset the "zero" point.

: Check the angle display at 20°, 45°, and 70°. The display must be within ±0.5 degrees of the inclinometer reading.

The filename n_031.mp4 frequently appears in technical contexts related to crane systems, specifically associated with documentation for the DS 350 and EI 65 series Load Moment Indicators (LMI). n_031.mp4

: Set the boom between 0 and 5 degrees. Use an inclinometer to verify the actual physical angle.

: Connect a voltmeter to the main board (Black to MP15 , Red to MP4/MP5 ). Adjust potentiometers P4 or P5 to reach exactly 0.500V (500mV) . : Fully retract the boom

Detailed wiring diagrams and flowcharts can be found in the PAT DS350 Service Manual or via WIKA Mobile Control Support . LENGTH-ANGLE-RADIUS-LOAD INDICATING SYSTEM

: Test that the system successfully disables crane functions during an overload condition. The display must be within ±0

: Verify voltage at the sensor. Expected values are roughly 3.125V (0°) and 2.5V (45°) . 3. Pressure Transducer Maintenance